Stand for washing particulate filters

Description

High configuration and cost-effectiveness, suitable for small and medium-sized social repair shops.

The cleaning process is carried out inside the fully enclosed equipment, which will not cause secondary pollution to the workshop environment

By integrating high flow high-temperature water circulation technology, peak surge cleaning technology, and high-pressure air blowing technology, DOC, FAP, DPF, and SCR can all achieve efficient and thorough cleaning and dredging.

Cleaning technology:

• High-pressure water flow;
• Hydraulic shock combined with special cleaning granules;
• Algorithmic cleaning process

Eco-friendly, multi-stage filtration system. Up to 5 cleaning cycles without water replacement. Automatic measurement of filter contamination level. Cleanliness check after washing.

Power input AC380V/50Hz three-phase five wire system

Connection to compressed air supply – yes

Gas tank capacity (L) 25

Gas tank pressure (KG) 8

Equipment weight (KG) 470

Maximum power (KW) 13.5

Flow cube/hour 7

Working water temperature (℃) –  60-65

Maximum working temperature (℃) – 65

Functional features:

1. Circulating cleaning: The water pump, heater, post processor, filter, and working water tank form a circulating circuit. After 60 minutes of using specialized chemical solution for peak surge circulation cleaning, blockages in the post processor are dissolved, softened, and removed.
2. Rinse with clean water: The water pump injects clean water from the clean water tank into the DPF exhaust port, while filling the bottom and mesh of the DPF with water.
3. Air blowing: Instantly release high-pressure gas from the gas storage tank, which pushes the water stored at the bottom of the DPF to generate potential energy, pushing residual blockages into the cleaning chamber and rinsing the residual liquid in the carrier clean.